
Add to Cart
Outdoor 20W 900MHz Repeater Suburban District Use Amplifier Cellular GSM Booster for Voice
Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save somebody’s life.
Unfortunately, there are still some places where they can find themselves “out of coverage” ,no signal at all... Usually those places are either too far from the cell phone base station or located inside underground constructions, for example:
How can repeater bring your mobile phone better signal?
•The outside antenna catches low signal from operator servicer’s base station and delivers it to cell phone repeater through the connection cable (coax).
•After the signal is accepted by the mobile repeater, this device amplifies it.
•Then this amplified signal goes through the connection cable (coax) to the inside antenna.
•And after that, the amplified signal transmits to your cell phone.
• Finally, your cell phone will get good signal, never on and off
A regular cell phone repeater consists of: (full kit)
Specification should care about :
Model No | |||
Parameter data | Uplink | Downlink | |
Frequency Range | UL:890-915mhz | DL:935-960mhz | |
Output Power | 33±2dBm | 43±2dBm | |
Gain | 90dB | 95 dB | |
Bandwidth | 25M | ||
Automatic Gain Control | ≥ 20 dB | ||
Ripple in Band | ≤4dB | ||
Intermodulation Products | 9KHz~1GHz | ≤ -36 dBm | |
1GHz~12.75GHz | ≤ -30 dBm | ||
Spurious Emission | 9KHz~1GHz | ≤ -36 dBm | |
1GHz~12.75GHz | ≤ -30 dBm | ||
Noise Figure @ max. gain | ≤ 6 dB | ||
VSWR | ≤2 | ||
MTBF | >50000 hours | ||
Power Supply | AC:165~260V, 50Hz; | ||
Power Consumption | < 20W | ||
Impedance | 50 ohm | ||
Mechanical Specification | |||
RF Connector | N-Female | ||
Cooling | Heatsink Convection cooling | ||
Dimensions (D x W xH ) | 460*350*160 mm | ||
Weight | <15Kg | ||
Installation Type | Wall Installation | ||
Environment Conditions | IP40 | ||
Humidity | < 90% | ||
Operating Temperature | -10°C ~ 55°C |